Norma ASTM Standard Classification System for Specifying Plastic Materials1 by aletapia in astm. Find the most up-to-date version of ASTM D at Engineering ASTM D − Standard Classification System for Specifying Plastic Materials. R&B Inc. 편집자 주. ▫ 본 한글 본은 R&B Inc. 내부재료로 일부 용어는 표준용어.

Author: Vilrajas Aralar
Country: China
Language: English (Spanish)
Genre: Education
Published (Last): 5 October 2013
Pages: 378
PDF File Size: 11.73 Mb
ePub File Size: 7.96 Mb
ISBN: 803-4-94950-833-7
Downloads: 33690
Price: Free* [*Free Regsitration Required]
Uploader: Akinojora

This standard has either been superseded and replaced by a new version or discontinued. D Test Method for Plastics: If the document is revised or amended, you will be notified by email.

A system is thus established which, together with values describing additional requirements, permits as complete a description as desired of the selected material.

If necessary, additional control of these reinforcements shall be accomplished by the use of the suffix part of the system Section 7. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ICS Number Code Replaced by Test Methods D and D ASTM D e1. D — 00a: The reinforcement letter designations and associated tolerance levels are shown in Table 2.

  AIRFRAME STRESS ANALYSIS AND SIZING NIU PDF

ASTM D4000 – 16

Added expression of results for second letter H. Added ISO and -2 as references for second letter M.

These letters represent the standard abbreviations for plastics in accordance with Terminology D It indicates tensile strength, elongation, and tear strength. Cell Limits 4 40 2 It is not intended for the selection of materials.

Cell Limits 4 85 10 Already Subscribed to this document.

Added second letter N to permit expression of? Originally published as D — As the voice of the U.

Numbers d0400 Tests Thus, a letter designation G for glass-reinforced and 33 for percent of reinforcement, G33, speci? Standards Subscriptions from ANSI provides a money-saving, multi-user solution for accessing standards. A system is thus established which, together with values describing additional requirements, permits as complete a description as desired of the selected material.

Already Subscribed to this document.

ES 27 was removed; incorporated in Test Method D NOTE 5—The previous edition of this standard used three digits for group, class, and grade; is equivalent to We have no document history for this standard. Link to Active This link will always route to the current Active version of the standard.

  ELECTRO VOICE Q44 PDF

ASTM International – Standard References for ASTM D – 16

We have no amendments or corrections for this standard. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

These characteristics will be spelled out in detail and d4000 Conformance or nonconformance with the speci? If you feel that your astmm have not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address shown below.

Material selection should be made by those having expertise in the plastics field after careful consideration of the design and the performance required of the part, the environment to which it will be exposed, the fabrication process to be employed, d0400 inherent properties of the material not covered in this document, and the economic factors.