3G Universal Cellular Wireless Alarm Communicator 3GRF 3G -ADT ADT DSC GSM 3G Universal Cellular Backup Wireless Alarm Communicator. The DSC 3G universal wireless alarm communicator uses the HSPA 3G cellular network to transmit signals has been discontinued. The DSC’s 3G has. GSVAH Sealed Lead Acid Alarm Battery for the DSC 3G cellular 3G alarm DSC Wireless Cellular 3G GSM Alarm Communicator (3G).
|Published (Last):||5 November 2006|
|PDF File Size:||6.34 Mb|
|ePub File Size:||19.67 Mb|
|Price:||Free* [*Free Regsitration Required]|
Page 22 This equipment generates and uses radio frequency energy the end user.
DSC HSPA 3g Universal Cellular Alarm Communicator 3g3070
The 3G will not show signal strength until the SIM is active. Also See for 3G Installation manual – 24 pages. If this LED flashes, the following list gs, the specific trouble based on the number of flashes, by priority. Don’t show me this message again. Description 4 hours standby power capabilities. When powering the 3G Radio by an Access tsm or tags returned for replace- purchase, the product shall be free of defects in materials ment under warranty will be credited or replaced at DSC’s and workmanship under hsm use.
Electrical current drawn from this terminal is drawn directly from the power supply. The 3G has four open collector outputs capable of a maximum of 50mA. By pressing ‘print’ button you will print only current page.
3G – DSC Wireless Universal Cellular 3G Alarm Communicator
After the 3G generates a Kiss-off signal, it sends the next alarm or, if no further alarms need to be sent, the control panel goes on-hook. During the warranty option. The entire manual should be carefully read.
Internal wiring must be routed in a manner that prevents: Comments to this Manuals Your Name. This equipment generates and uses radio frequency energy the end user. Page 17 – 24h Test Transmission must be enabled on the dialler and on the 3G Products not covered by this warranty, or other Enter text from picture: The 3G indicates the status of the highest priority, unrestored trouble condition with the corresponding number of flashes of the red LED.
This must be added to the 3G current when determining the total draw on the host panel or power supply. Table Of Contents Installing the 3G Jumper JP3 does not limit the electrical current available on this output. Table of Contents Add to my manuals Add.
Internal rsc on the 3G can trigger the outputs to turn on an LED or activate an input on the host panel. Page 13 3G low battery trouble one flash and an insufficient signal strength trouble four flashes are present; the red light will flash one time.
This manual contains information on limitations regarding product. To print the manual completely, please, download it. Page of 23 Go. This manual contains information on limitations regarding product use and function and information on the limitations as to liability of the manu- facturer.
Outputs The 3G has four open collector outputs capable of a maximum of 50mA. Once the 3G low battery trouble condition is corrected, the red light will then begin flashing four times. Got it, continue to print. DSC Software purchased with or without Products and Components is copyrighted and is purchased under the following license terms: The default settings are as follows. Don’t have an account? When turned on, the 3G checks for the trouble conditions to be dscc in the order listed below.
YELLOW light will flash one time when the signal is transmitted gwm two times when it gets a kiss-off. Page 23 Access cards or tags returned for replace- purchase, the product shall be free of defects in materials ment under warranty will be credited or replaced at DSC’s and workmanship under normal use.